 |
| POLICE
EQUIPMENT |
Products
Quick Find: |
|
| |
|
 1 2 3  |
|
BALLISTIC
TACTICAL SHIELDS
The new Fortress Pacific’s ballistic tactical shields is made of composite
fabrics. with ideal handle and good design provide SWAT and special service forces
person maximum protection in the performance of their duty in exposed or non-covered
areas.
Designed & installed place of arm clasps and hand grip on shield comply with
the strength theory, enable user to save energy and prolong time of carry, holding
steadable and convenient, not only can be held by single hand but also can be
held by two hands just depends on different situation. There is an ant-impact
EVA foam on arm place, arm clasps is adjustable to meet your arm size and fasten.
This shield is also available for right hand use only to change the install places
of arm clasps and hand grip.
Anther alternative equipment of Fortress Pacific’s tactical shield is "Gun
Port", an 25mm diameter covered by shock-absorbed rubber, affords rifle,
sub-machinegun and most of handgun shotting, and for shooting while attacking.
Around the gun port, ballistic resistance is enhanced, and a ballistic cover
on rear side of gun port also provides ballistic ability while gun port is no
used and to be covered by the ballistic cover. |
| Model No. |
Armor Type |
Size |
Weight |
| EPS-05KG |
IIIA |
L.85_W.50Cm R 50
L.16_W.9Cm(Glass) |
6.0kg |
| EPS-05KM |
IIIA |
L.90_W.55Cm Flat
L.23_W.16Cm(Glass) |
7.0kg |
| EPS-05KL |
IIIA |
L.120_W.70Cm Flat
L.39_W.16Cm(Glass) |
10.5kg |
|
 |
BALLISTIC FACEMASK
Model B. full face Model A. part of face (combined with helmet)
This tactical facemask affords ballistic resistant TypeII & III
A protection (NIJSTD-0108.01)over the covered facial area, fastened
with 6 straps, inner cushion pad allow maximun air flow and talk.
MODEL B MODEL A
Weight: Armor TypeII 0.9 kg 0.6 kg
Armor Type: 1.0kg 0.7kg |
| |
|
1 2 3 |
|
Products
Quick Find: |
|
|
